Silver Lining

  • About Me
  • Drone Services
  • Consultancy
  • YouTube channel
  • Testing The Tesla Shop
    • Cart

LED Cube

Arduino

Building an LED cube powered by Arduino (part 7)

In the previous part of this online LED cube tutorial we’ve finished the entire hardware side of the cube. Now, while that’s looking awesome, it is still a dead object. In this final part I’ll guide you through the steps to get started in the Arduino environment, so you can […]

By Steven Peeters, 11 years3 years ago
Arduino

Building an LED cube powered by Arduino (part 6)

So, in the previous part I’ve shown you how to solder your prototype board to get the power circuit from the power connector to every single component. We’ve also added a few capacitors to regulate the power. Now it is time to solder the actual data circuit wires in place. […]

By , 11 years3 years ago
Arduino

Building an LED cube powered by Arduino (part 5)

So now you have the cube all wired up, it’s time to direct our attention to the actual prototype board. This is going to become the actual brain of the LED cube. It is not that difficult top build, but you need some basic knowledge of electronics to get it […]

By , 11 years3 years ago
  • About Me
  • Drone Services
  • Consultancy
  • YouTube channel
  • Testing The Tesla Shop
Privacy policy
This website uses cookies to improve your experience. We'll assume you accept this policy as long as you are using this website.AcceptView Policy