Physical computing

In the previous part of this online LED cube tutorial we’ve finished the entire hardware side of the cube. Now, while that’s looking awesome, it is still a dead object. In this final part I’ll guide you through the steps to get started in the Arduino environment, so you can […]

So, in the previous part I’ve shown you how to solder your prototype board to get the power circuit from the power connector to every single component. We’ve also added a few capacitors to regulate the power. Now it is time to solder the actual data circuit wires in place. […]

So now you have the cube all wired up, it’s time to direct our attention to the actual prototype board. This is going to become the actual brain of the LED cube. It is not that difficult top build, but you need some basic knowledge of electronics to get it […]